The contaminants include water to be removed from the surface prior to penetrant application Contaminant termasuk air harus dihilangkan dari permukaan sebelum aplikasi penetrant a. True b. False We have indications with the dimension as follows: The indication no.1 dimension is 1mmwidthtimes 3.5mmlength; Indication no. 2 dimension is 2mmwidthtimes 3mmlength; they are separated by 6 mm. Kita punya indication dengan ukuran seperti berikut : Indication no. 1 berukuran 1mmwidthtimes 3.5mmlength, Indication no. 2 berukuran 2mmwidthtimes 3mmlength, mereka terpisahkan dengan 6 mm. a. indication no.1 is rejected b. indication no 2. is rejected c. indication no. 1 is accepted d. indication no 2. is accepted e. a and d correct f. all of the above. Accepted The following is the correct statement in according to the AMS-02, regarding the indication regardi ini adalah pernyataan yang benar sesuai dengan AMS - 02, tentang indication a. indication is the same with the discontinuity b. indication is the same with the defect c. indication may be larger than the discontinuity d. indication is smaller than the discontinuity e. indication is no relation with the discontinuity f. none of the above g. all of the above The developer shall be applied Developer harus diaplikasikan a. after the penetrant on the part minimum 10 minutes b. maximum 10 minutes after the excess penetrant has been removed c. no requirement d. none of the above Shot blasting over the surface of the parts being penetrant tested is not allowed, why allowed. Why pada permukaan yang diuji dengan penetrant tiadak diperbolehkan, mengapa? d. production cost will be increased b. it is depend on fabricator decision c. the temperature is the driver