9. The purpose of penetrant system monitoris to provide a. A method of eatimating the cost of inspection b. Verification of the overall processing system performance c. Standardization for performing process controls d. The means to reject fest objects 10. The penetrant process best suited to use on parts with rough surfaces is: a. Solvent removable b. Water washable c. Post emulsifiable d. Magnetic Particle 11. Dry developer is checked for fluorescentcontamination by: a. Comparing the in-use developer to new material b. Processing a testing and monitoring panel c. A laboratory examination for chemical composition d. Viewing under an ultraviolet light for fluorescent speeks 12. Ultraviolet lights over a fluorescent penetrant wash station are used to: a. Verify a uniform coating of penetrant has been applied to the part b. Verify the emulsifier covers the entire c. Monitor the removal of surface penetrant d. Check the cleanliness of parts before processing 13. Which of the following is most likely to render the post emulsification test ineffective? a. The penetrant time is too long b. The developing time is too long